FIND EVERYTHING HERE
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Mauris a enim aliquam, condimentum nisl a, laoreet lectus. Aliquam convallis sed elit nec vehicula. Praesent gravida, massa sit amet ullamcorper fringilla, tortor nunc ultrices dui, in tristique leo leo sed massa.
Quisque et lectus pulvinar, porttitor mi non, elementum dui. Morbi mi nisl, tincidunt sed venenatis eget, finibus eu mauris. Nullam nisi lacus, feugiat eget varius eget, pellentesque dictum odio. Sed sollicitudin viverra est, at aliquam metus ultrices id. Duis eu purus vel nisl commodo facilisis vitae ut lectus. Quisque et lectus pulvinar, porttitor mi non, elementum dui. Morbi mi nisl, tincidunt sed venenatis eget, finibus eu mauris. Nullam nisi lacus, feugiat eget varius eget, pellentesque dictum odio. Sed sollicitudin viverra est, at aliquam metus ultrices id. Duis eu purus vel nisl commodo facilisis vitae ut lectus.
- Make sure all Idler Rolls are clean and rotating properly.
- Make sure that the web has not, inadvertently, been routed over a dead bar.
- If the press is equipped with a turn bar make sure there is adequate air supplied to the device and the air holes are not plugged. (60 PSI at 4 SCFM)
- Observe the oil level and the cleanliness of the gear box oil.
- Make sure the gear box mount cap screws are tight and the locating pins are in place.
- Make sure all the cap screws affixing the flanges to the gear boxes are tightened properly. These flanges are load bearings that secure the input and output shafts. These cap screws tend to work loose initially with the heating and cooling of the gear boxes.
Check the disc on the infeed pacing roll tension brake for excessive runout. This runout should not exceed 0.002″.
Check the disc on the infeed pacing roll tension brake for excessive runout. This runout should not exceed 0.002″.
Check the disc on the infeed pacing roll tension brake for excessive runout. This runout should not exceed 0.002″.